Home › ENGINE ยท 2AZ-FE › STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE AIR CLEANER INLET ASSEMBLY


    A134903
  1. Remove the 2 bolts, clamp and air cleaner inlet.



3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A135666E01
  1. Disconnect the mass air flow meter connector (*1).

  1. Disconnect the purge VSV connector (*2).

  1. Disconnect the 2 purge VSV vacuum hoses (*3).

  1. Disconnect the purge line hose from the clamp (*4).



    A135667E01
  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.



    A135668
  1. Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.



    A135669
  1. Remove the 2 bolts and air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.



4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A134905
  1. Disconnect the hose clamp.

  1. Remove the 3 bolts and air cleaner case.



5. REMOVE STARTER ASSEMBLY (for Manual Transaxle)


    A133565
  1. Disconnect the terminal 50 connector from the starter assembly.

  1. Remove the nut and disconnect the wire harness from terminal 30.



    A133566E01
  1. Remove the 3 bolts, clutch flexible hose bracket and starter assembly.



6. REMOVE STARTER ASSEMBLY (for Automatic Transaxle)


    A134876
  1. Disconnect the terminal 50 connector from the starter assembly.

  1. Remove the nut and disconnect the wire harness from terminal 30.



    A134877
  1. Remove the 2 bolts and starter assembly.