Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER RELAY

WIPER RELAY > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures for the RH side and the LH side.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedures for the RH side and the LH side.



3. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY


    B133988E01
  1. Disengage the 4 claws.

  1. Disengage the 2 guides and remove the No. 2 under cover sub-assembly.



4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the bolt <A>.



    B133992E01
  1. Remove the 4 screws <B>.

  1. Disengage the 3 claws and 3 clips, and then remove the lower instrument panel sub-assembly.



5. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY


    E128848
  1. Disconnect the connector.

  1. Remove the nut and the windshield wiper relay assembly.