RAIN SENSOR > INSTALLATION |
| 1. INSTALL RAIN SENSOR TAPE |
![]() |
Remove the releasing sheet (yellow side) from new rain sensor tape and attach the tape to the position indicated in the illustration (the sensor part of the rain sensor) while pushing out air bubbles with your fingers.
Remove the releasing sheet (white side) from the rain sensor tape.
| Area | Measurement |
| A | 7.3 mm (0.287 in.) |
| B | 13.5 mm (0.531 in.) |
| 2. INSTALL RAIN SENSOR |
![]() |
Connect the connector.
![]() |
Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.
Push in the stopper.
| 3. INSTALL RAIN SENSOR COVER |
![]() |
Install the rain sensor cover.