Home › BODY ELECTRICAL › WIPER AND WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)


    B138886
  1. Remove the 7 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY


    B220943E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B220944
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B220945
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. w/ TOYOTA Parking Assist-sensor System:

    1. Disengage the clamp and disconnect the No. 1 ultrasonic sensor connector.

  1. w/ Headlight Cleaner System:

    1. Disconnect the headlight cleaner washer hose.



    B137737
  1. Remove the front bumper assembly.



3. REMOVE HEADLIGHT CLEANER ACTUATOR SUB-ASSEMBLY


    E150394
  1. Extend the headlight cleaner nozzle.

  1. Disengage the claw and remove the headlight cleaner nozzle with nozzle holder as shown in the illustration.



    E183136
  1. Disengage the 2 claws and remove the headlight cleaner nozzle sub-assembly.



    E182203
  1. Disconnect the headlight washer hose.

  1. Remove the bolt.



    E182204
  1. Disengage the 2 claws and remove the headlight cleaner actuator sub-assembly.