DTC B1422/22 Compressor Lock Sensor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1422/22 | Open or short in compressor lock sensor circuit |
|

| 1.CHECK CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check if the CAN Communication System is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.INSPECT AIR CONDITIONING AMPLIFIER |
![]() |
Remove the A/C amplifier with the connectors still connected.
![]() |
Measure the waveform of the connector.
| Item | Contents |
| Tool setting | 200 mV/DIV., 10 ms./DIV. |
| Vehicle condition | Engine is running A/C switch: ON Blower switch: LO |
| Tester Connection (Symbols) | Condition | Specified Condition |
| E38-8 (LOCK) - E38-13 (SG-2) | Engine is running A/C switch: ON Blower switch: LO | Pulse generation |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE) | B |
| OK (When troubleshooting according to the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 3.INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR) |
![]() |
Disconnect the connector from the A/C compressor.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C53-1 (SSR+) - C53-2 (SSR-) | Always (at 20°C (68°F)) | 160 to 320 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - A/C LOCK SENSOR) |
![]() |
Disconnect the connector from the A/C amplifier.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| E38-8 (LOCK) - C53-1 (SSR+) | Always | Below 1 Ω |
| E38-13 (SG-2) - C53-2 (SSR-) | Always | Below 1 Ω |
| E38-8 (LOCK) - Body ground | Always | 10 kΩ or higher |
| E38-13 (SG-2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||