Home › BODY ELECTRICAL › AUDIO / VISUAL › AMPLIFIER ANTENNA

AMPLIFIER ANTENNA > INSTALLATION

for Preparation Click here



1. INSTALL AMPLIFIER ANTENNA ASSEMBLY


    E129183
  1. Install the amplifier antenna assembly with the bolt.

  1. Connect each connector.



2. INSTALL ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedures for the RH side and the LH side .



3. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (for Reclining Seat Type)

HINT:
Use the same procedures for the RH side and the LH side .



4. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH


    B132082E01
  1. Install the rear door opening trim weatherstrip RH as shown in the illustration.

    NOTICE:
    After installation, check that the corners fit correctly.



5. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures for the RH side and the LH side .



6. INSTALL SEPARATE TYPE REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type)


    B139079
  1. Install the separate type rear seatback assembly RH with the 2 bolts and 2 nuts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    B139082E01
  1. Engage the 3 clamps and install the cover.



    B139078E01
  1. Install the rear seat belt.



7. INSTALL REAR SEATBACK COVER (for Reclining Seat Type)


8. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)

HINT:
Use the same procedures for the RH side and the LH side .



9. INSTALL SEPARATE TYPE REAR SEATBACK ASSEMBLY RH (for Fold Down Seat Type)


    B134700
  1. Install the separate type rear seat back assembly with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



10. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY (for Fold Down Seat Type)


11. INSTALL REAR SEAT HEADREST ASSEMBLY


12. INSTALL REAR SEAT CUSHION ASSEMBLY


    B140584E01
  1. Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.

    NOTICE:
    When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.