Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT SIDE SPEAKER

FRONT SIDE SPEAKER > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B132833
  1. Disengage the 2 clips and remove the front door lower frame bracket garnish.



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B132834E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.



3. REMOVE ASSIST GRIP COVER


    B132836E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.



4. REMOVE COURTESY LIGHT ASSEMBLY


    B132838E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.

  1. Disconnect the connector.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B132840E01
  1. Remove the 3 screws and clip (A).

  1. Using a clip remover, disengage the 9 clips.



    B136401E01
  1. Pull up the front door trim board in the direction indicated by the arrow.

  1. Disengage the reference bosses from the front door panel.

  1. Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.



    B136403
  1. Disengage the 2 claws and disconnect the front door inside handle sub-assembly.



6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    B136404
  1. Using a screwdriver, disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.



7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    E129164
  1. Disconnect the connector.

  1. Remove the 4 bolts and front No. 1 speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.



8. REMOVE FRONT PILLAR GARNISH


    B132056E01
  1. Pull the upper part of the garnish toward the inside of the cabin and disengage the 2 clips.

  1. Cut off the clip <A>.

  1. Disengage the 2 claws and remove the front pillar garnish LH.

  1. Remove the clip <A> from the vehicle body.



    B132100E01
  1. Protect the curtain shield airbag assembly.

    1. Cover the airbag with a 700 mm (27.56 in.) x 120 mm (4.72 in.) cloth or piece of nylon and fix the ends of the cover with tape, as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.



9. REMOVE INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY


    E129166E01
  1. Engage the 6 claws and 2 clips.

  1. Remove the instrument panel No. 2 speaker panel sub-assembly.



10. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    E129167
  1. Remove the 2 bolts and front No. 2 speaker assembly.

  1. Disconnect the connector.