Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO RECEIVER

RADIO RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL RADIO RECEIVER ASSEMBLY


    E131405
  1. Install the radio receiver assembly as shown in the illustration.



2. INSTALL RADIO NO. 2 BRACKET


    E131403
  1. Install the radio No. 2 bracket with the 5 bolts.



3. INSTALL RADIO NO. 1 BRACKET


    E131402
  1. Install the radio No. 1 bracket with the 5 bolts.



4. INSTALL RADIO RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY


    E131401
  1. Connect each connector.

  1. Engage the 4 clips.

  1. Install the radio receiver with heater control panel assembly with the 4 bolts.



5. INSTALL INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY
  1. Connect the connector.



    B134001
  1. Engage the 7 clips and install the instrument panel No. 2 register assembly.



6. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY
  1. Connect each connector.



    B141243E01
  1. Engage the 2 claws and 2 clips.

  1. Install the lower instrument cluster finish panel center sub-assembly with the 2 screws <F>.



7. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle)


    B144603E01
  1. Connect the connector and engage the clamp.

  1. Engage the 3 claws and 5 clips to install the upper console rear panel sub-assembly.



8. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle)


    B144604
  1. Engage the 3 claws and 5 clips to install the upper console rear panel sub-assembly.



9. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle)
  1. with Seat Heater System:

    1. Connect each connector.



    B148447
  1. Engage the 6 claws and the 3 clips to install the floor shift position indicator housing sub-assembly.



10. INSTALL UPPER CONSOLE PANEL (for Manual Transaxle)


    B145877
  1. Engage the 2 claws and the 5 clips to install the upper console panel as shown in the illustration.



11. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B144605
  1. Engage the 2 clips and install the No. 2 instrument cluster finish panel garnish.



12. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B144599
  1. Engage the 2 clips and install the No. 1 instrument cluster finish panel garnish.



13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle)


    B148448
  1. Install the shift lever knob sub-assembly.



14. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    B144601
  1. Install the shift lever knob sub-assembly.