THEFT DETERRENT SYSTEM (w/ Entry and Start System) > SYSTEM DESCRIPTION |
| OUTLINE OF THEFT DETERRENT SYSTEM |
Disarmed state:
Arming preparation state:
Armed state:
Alarm sounding state:
| Alarm Method | Hazard Warning Lights | Blinking |
| Vehicle Horns | Sounding (approx. 0.4-second cycles) | |
| Security Horn | Sounding (approx. 0.4-second cycles) | |
| Alarm Time | Approx. 27.5 sec. | |
| FUNCTION OF MAIN COMPONENTS |
| Component | Function |
| Security indicator | Informs driver of theft deterrent system status. |
| Security horn | Sounds when attempted break-in or theft is detected. |
| Hazard warning lights | Blink when attempted break-in or theft is detected. |
| Vehicle horns | Sound when attempted break-in or theft is detected. |
| Door courtesy light switch | Detects door status (open or closed). |
| Door lock position switch | Detects door status (locked or unlocked). |
| Engine hood courtesy switch | Detects engine hood status (open or closed). |
| Luggage compartment door courtesy switch | Detects luggage compartment door status (open or closed). |
| Certification ECU (smart key ECU assembly) |
|
| ACTIVE ARMING MODE |
Active arming mode:
This system activates as described in the diagram below when one of the items for each condition is met.

| Condition | Item |
| Condition (1) | In the disarmed state 1, when the key is not in the actuation area, the system state is switched if the following condition is met: With all doors, engine hood and luggage compartment door closed, lock all doors by wireless operation or entry and start system. |
| Condition (2) | After condition (1) is met, allow approx. 30 seconds to elapse. |
| Condition (3) |
|
| Condition (4) |
|
| Condition (5) |
|
| Condition (6) | After approx. 27.5 seconds, the alarm stops and 5 seconds later the system returns to the armed state. |
| Condition (7) | Open the luggage compartment door by wireless operation. |
| Condition (8) |
|
| Condition (9) |
|
| Condition (10) | In the disarmed state 1, when the key is not in the actuation area, the system state is switched if the following condition is met: With all doors closed, and the engine hood or luggage compartment door is opened, lock all doors by wireless operation or entry and start system. |
| Condition (11) | With engine hood or luggage compartment door opened, open the luggage compartment door by wireless operation. |
| FORCED DOOR LOCK CONTROL |
The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (alarm starts), the door is forced to lock by a forced door lock signal.
Conditions that force the doors to lock:
When the key is not in the actuation area and both of the following conditions are met:
| SECURITY INDICATOR OUTPUT |
The certification ECU outputs a signal to come on the security indicator, according to the state of the theft deterrent system. However, some of the actual lighting conditions of the security indicator are different from the output signals of the certification ECU.
| State of Theft Deterrent System | Security Indicator | |
| Output Signals from Certification ECU | Actual Lighting Condition | |
| Disarmed state 1, 2 | OFF | OFF (Immobiliser system unset) BLINKING (Immobiliser system set) |
| Arming preparation state | ON | ON |
| Armed state | OFF | BLINKING |
| Alarm sounding state | ON | ON |
| Time | Security Indicator |
| 0.125 sec. | ON |
| 1.875 sec. | OFF |