Home › ENGINE · 2GR-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    A119190E04
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Condition
      Tester Connection
      Specified Condition
      LOCK
      Between all terminals
      10 kΩ or higher
      ACC
      2 - 4
      Below 1 Ω
      ON
      1 - 2 - 4
      Below 1 Ω
      5 - 6
      START
      1 - 3 - 4
      Below 1 Ω
      5 - 6 - 7

      If the result is not as specified, replace the ignition or starter switch.