DTC P0877 Transmission Fluid Pressure Sensor / Switch "D" Circuit Low |
DTC P0878 Transmission Fluid Pressure Sensor / Switch "D" Circuit High |
| DTC No. | DTC Detecting Condition | Trouble Area |
| P0877 | ATF pressure switch No. 2 OFF is detected twice when any of the gears from 4th to 6th engages normally. |
|
| P0878 | ATF pressure switch No. 2 ON is detected twice when any of the gears from 1st to 3rd engages normally. |

| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0877 OR P0878) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on and turn the intelligent tester on.
Enter the following items: "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only "P0878" is output | A |
| Only "P0877" is output | B |
| "P0877 or P0878" and other DTCs | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK TRANSMISSION WIRE (SHORT TO GROUND) |
![]() |
Remove the TCM.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
| 20 (TPS2) - Body ground (Valve body assembly) | 10 kΩ or higher |
|
| ||||
| NG | |
| 3.CHECK ATF TEMPERATURE SENSOR ASSEMBLY (ATF PRESSURE SWITCH NO. 2) |
![]() |
Disconnect the connector from the ATF temperature sensor assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
| 4 (TPS2) - Body ground (Valve body assembly) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK TRANSMISSION WIRE |
![]() |
Remove the TCM.
Disconnect the speed sensor connector from the transmission wire.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
| 20 (TPS2) - 4 (TPS2) | Below 1 Ω |
| 20 (TPS2) or 4 (TPS2) - Body ground (Valve body assembly) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||