Home › TRANSMISSION · U660E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    P0989    Transmission Fluid Pressure Sensor / Switch "E" Circuit Low

DTC    P0990    Transmission Fluid Pressure Sensor / Switch "E" Circuit High

for Preparation Click here


DESCRIPTION

ATF pressure switch No. 3 is installed in the lockup solenoid ATF output passage and is used to detect a malfunction in the lockup solenoid.

DTC No.
DTC Detection Condition
Trouble Area
P0989
Transmission fluid pressure switch No. 3 is OFF when lock-up occurs in response to a lock-up request (2 trip detection logic).
  1. ATF temperature sensor assembly (ATF pressure switch No. 3)
  1. Transmission wire
  1. TCM
P0990
When both of the following are detected (2 trip detection logic):
  1. Transmission fluid pressure switch No. 3 is ON when lock-up does not occur.
  2. Lock-up does not occur when shift solenoid valve (SLU) is requested to turn off in the lock-up range.

MONITOR DESCRIPTION

The TCM illuminates the MIL and stores the DTC when the TCM detects that the ATF pressure switch is OFF with the lock-up solenoid ON or when the TCM detects that the ATF pressure switch is ON with the lock-up solenoid OFF.

WIRING DIAGRAM


C133258E06


INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0989 OR P0990)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on and turn the intelligent tester on.

  1. Enter the following items: "Powertrain / ECT / DTC / Current or Pending".

  1. Read the DTCs using the intelligent tester.

    Result:

    Display (DTC output)
    Proceed to
    Only "P0990" is output
    A
    Only "P0989" is output
    B
    "P0989 or P0990" and other DTCs
    C

    HINT:
    If a solenoid is stuck OFF, DTCs for several solenoids including the malfunctioning solenoid will be detected.



B
Go to step 4

C
GO TO DTC CHART
A


2.CHECK TRANSMISSION WIRE (SHORT TO GROUND)


    C133212E12
  1. Remove the TCM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Condition
    Specified Condition
    19 (TPS3) - Body ground (Valve body assembly)
    10 kΩ or higher



OK
REPLACE TCM
NG


3.CHECK ATF TEMPERATURE SENSOR ASSEMBLY (ATF PRESSURE SWITCH NO.3)


    C142709E01
  1. Disconnect the connector from the ATF temperature sensor assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Condition
    Specified Condition
    5 (TPS3) - Body ground (Valve body assembly)
    10 kΩ or higher



NG
REPLACE ATF TEMPERATURE SENSOR ASSEMBLY
OK

REPLACE TRANSMISSION WIRE 

4.CHECK TRANSMISSION WIRE


    C133269E03
  1. Remove the TCM.

  1. Disconnect the speed sensor connector from the transmission wire.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Condition
    Specified Condition
    19 (TPS3) - 5 (TPS3)
    Below 1 Ω
    19 (TPS3) or 5 (TPS3) - Body ground (Valve body assembly)
    10 kΩ or higher



NG
REPLACE TRANSMISSION WIRE
OK

REPLACE ATF TEMPERATURE SENSOR ASSEMBLY