STARTER > INSTALLATION |
| 1. INSTALL STARTER ASSEMBLY |
![]() |
Install the starter assembly with the 2 bolts.
Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.
Connect the terminal 50 connector to the starter assembly.
| 2. INSTALL NO. 1 AIR CLEANER INLET |
![]() |
Install the No. 1 air cleaner inlet with the bolt.
| 3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Install the air cleaner case with the 3 bolts.
Connect the vacuum hose and hose clamp.
| 4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Install the air cleaner cap sub-assembly, and connect the 3 bands.
![]() |
Connect the mass air flow meter connector (*1).
Connect the No. 2 ventilation hose (*2).
Connect the hose band (*3).
![]() |
Connect the 3 vacuum hoses.
| 5. INSTALL AIR CLEANER INLET ASSEMBLY |
![]() |
Install the air cleaner inlet with the clamp and 2 bolts.
| 6. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Engage the 3 retainers to install the V-bank cover.
| 7. INSTALL COOL AIR INTAKE DUCT SEAL |
![]() |
Install the intake duct seal with the 7 clips.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |