Home › TRANSMISSION ยท U660E AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY


    C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.



2. REMOVE STATOR SHAFT ASSEMBLY


    C138275
  1. Using a "TORX" wrench (T30), remove the 16 bolts and stator shaft assembly from the oil pump body.

    NOTICE:
    Keep the gears in the order of installation.



3. INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY


    C138509
  1. Push the driven gear to one side of the body.

  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    0.08 to 0.15 mm (0.0031 to 0.0059 in.)

    Maximum clearance:
    0.15 mm (0.0059 in.)

    If the clearance is greater than the maximum, replace the oil pump body sub-assembly.



    C138511
  1. Using a straight edge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.025 to 0.04 mm (0.0010 to 0.0016 in.)


    Maximum side clearance:
    0.04 mm (0.0016 in.)
    Drive gear thickness: 
    Mark
    Thickness
    -
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    -
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    -
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    -
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    -
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)
    Driven gear thickness: 
    Mark
    Thickness
    -
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    -
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    -
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    -
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    -
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)



4. REMOVE FRONT OIL PUMP BODY O-RING


    C138278
  1. Remove the O-ring from the oil pump body.



5. REMOVE FRONT OIL PUMP DRIVE GEAR


    C138276
  1. Remove the front oil pump drive gear from the oil pump body.



6. REMOVE FRONT OIL PUMP DRIVEN GEAR


    C138277
  1. Remove the front oil pump driven gear from the oil pump body.



7. REMOVE FRONT OIL PUMP OIL SEAL


    C138508E01
  1. Mount the oil pump in a soft jaw vise.

  1. Using SST, remove the oil seal from the oil pump body.

    SST
    09308-00010