Home › TRANSMISSION ยท U660E AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    C138515E01
  1. Using SST and a hammer, install a new oil seal to the oil pump body.

    SST
    09350-32014   (09351-32140)

    NOTICE:
    The seal end should be level with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with MP grease.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C138278
  1. Coat a new O-ring with ATF and install it to the oil pump body.

    NOTICE:
    Ensure that the O-ring is not twisted.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    C138277
  1. Coat the front oil pump driven gear with ATF and install it to the oil pump body with the marked side up.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    C138276
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.



5. INSTALL STATOR SHAFT ASSEMBLY


    C138275E01
  1. Align each knock pin of the stator shaft with the holes in the oil pump body and install the stator shaft to the oil pump body with the 16 bolts.

  1. Using a "TORX" socket (T30), install the 11 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

    -
    -
    Bolt length:
    Bolt length:
    Bolt A
    Bolt A
    14 mm (0.55 in)
    Bolt B
    Bolt B
    26 mm (1.02 in)



6. INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY


    C138512
  1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.