SFI SYSTEM > Fuel Pump Control Circuit |


| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE C/OPN RELAY) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Select the following menu items: Powertrain / Engine / Active Test / Fuel Pump / Speed.
Check whether the fuel pump operation sound occurs when performing the Active Test on the tester.
|
| ||||
| OK | ||
| ||
| 2.CHECK ECM POWER SOURCE CIRCUIT |
|
| ||||
| OK | |
| 3.INSPECT ENGINE ROOM JUNCTION BLOCK (C/OPN RELAY) |
![]() |
Remove the integration relay from the engine room relay block.
Inspect the C/OPN relay.
Measure the C/OPN relay resistance.
| Tester Connection | Specified Condition |
| 1E-7 - 1E-13 | 10 kΩ or higher |
| Below 1 Ω (Apply battery voltage between terminals 1D-12 and 1E-8) |
Reinstall the integration relay.
|
| ||||
| OK | |
| 4.INSPECT ECM (FC VOLTAGE) |
![]() |
Disconnect the C58 (RHD) or C55 (LHD) and A24 (RHD) or A55 (LHD) ECM connectors.
Measure the voltage between the terminals.
| Tester Connection | Specified Condition |
| FC (A24-7) - E1 (C58-81) | 11 to 14 V |
| Tester Connection | Specified Condition |
| FC (A55-7) - E1 (C55-81) | 11 to 14 V |
Reconnect the ECM connectors.
|
| ||||
| OK | |
| 5.INSPECT FUEL PUMP |
Inspect the fuel pump (Click here).
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (C/OPN RELAY - FUEL PUMP - BODY GROUND) |
![]() |
Check the harness and the connectors between the engine room relay block and the fuel pump.
Disconnect the integration relay connector.
Disconnect the N10 fuel pump connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| 1E-13 - N10-4 (Fuel pump) | Below 1 Ω |
| Tester Connection | Specified Condition |
| 1E-13 or N10-4 (Fuel pump) - Body ground | 10 kΩ or higher |
Check the harness and the connectors between the fuel pump and body ground.
Disconnect the N10 fuel pump connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| N10-5 (Fuel pump) - Body ground | Below 1 Ω |
Reconnect the integration relay connector.
Reconnect the fuel pump connector.
|
| ||||
| OK | ||
| ||