FUEL SENDER GAUGE ASSEMBLY (for 2GR-FE) > INSTALLATION |
| 1. INSTALL FUEL SENDER GAUGE ASSEMBLY |
![]() |
Slide the fuel sender gauge to engage with the claw (*1).
Connect the fuel sender gauge connector (*2).
| 2. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
![]() |
Install a new gasket to the fuel suction tube.
Install the fuel suction tube.
| 3. INSTALL FUEL TANK VENT TUBE SET PLATE |
![]() |
Align the mark of the set plate with the fuel suction tube.
Install the set plate with the 8 bolts.
| 4. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Install the fuel pump tube with the tube joint clip.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. CHECK FOR FUEL LEAKS |
| 7. INSTALL REAR FLOOR SERVICE HOLE COVER |
![]() |
Connect the fuel pump connector.
Install the rear floor service hole cover with new butyl tape.
| 8. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
![]() |
Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.
Confirm that the seat cushion is firmly installed.
| 9. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
![]() |
Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.
Confirm that the seat cushion is firmly installed.