AMBIENT TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL AMBIENT TEMPERATURE SENSOR |
![]() |
Install the ambient temperature sensor with the clamp.
Connect the connector.
| 2. INSTALL FRONT BUMPER ASSEMBLY |
w/ Headlight Cleaner System:
![]() |
Connect the headlight cleaner washer hose.
Connect each connector.
w/ TOYOTA Parking Assist-sensor System:
Connect the No. 1 ultrasonic sensor connector and engage the clamp.
![]() |
Engage the 2 claws.
![]() |
Install the front bumper assembly with the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
![]() |
Install the pin hold clip.
![]() |
Remove the applied protective tape on the front bumper assembly.
| 3. INSTALL COOL AIR INTAKE DUCT SEAL |
![]() |
Install the cool air intake duct seal with the 7 clips.
| 4. VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) |
Prepare the vehicle:
| 5. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) |
![]() |
Prepare the vehicle:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
Draw a vertical line down the center of screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H, V LH, and V RH lines) on the screen as shown in the illustration.
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the low-beam fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw two vertical lines so that they intersect the H line at each center mark.
| 6. FOG LIGHT AIMING INSPECTION (w/ Fog Light) |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.
Start the engine.
Turn on the fog light and check if the cut off line falls within the specified area in the following illustration.

| 7. ADJUST FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) |
![]() |
Adjust the aim vertically:
Adjust the aim of each fog light to the specified range by turning each aiming screw with a screwdriver.