Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR

AMBIENT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)


    B138886
  1. Remove the 7 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY


    B220943E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B220944
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B220945
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. w/ TOYOTA Parking Assist-sensor System:

    1. Disengage the clamp and disconnect the No. 1 ultrasonic sensor connector.

  1. w/ Headlight Cleaner System:

    1. Disconnect the headlight cleaner washer hose.



    B137737
  1. Remove the front bumper assembly.



3. REMOVE AMBIENT TEMPERATURE SENSOR


    E128543
  1. Disconnect the connector and detach the clamp.

  1. Remove the ambient temperature sensor.