COMPRESSOR AND PULLEY (for 2AZ-FE) > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Turn the A/C switch on.
Operate the cooler compressor at an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
| 2. DISCONNECT REFRIGERANT FROM REFRIGERATION SYSTEM |
| 3. DRAIN ENGINE COOLANT |
Remove the radiator cap sub-assembly from the radiator assembly.
Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.

| 4. REMOVE FRONT WHEEL RH |
| 5. REMOVE ENGINE UNDER COVER RH |
| 6. REMOVE FRONT FENDER APRON SEAL RH |
| 7. REMOVE V-RIBBED BELT |
![]() |
Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
| 8. REMOVE GENERATOR ASSEMBLY |
![]() |
Disconnect the generator connector.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and wire harness clamp bracket.
Remove the wire harness clamps.
![]() |
Remove the 2 bolts and generator assembly.
| 9. DISCONNECT RADIATOR HOSE OUTLET |
![]() |
Using pliers, grip the claws of the clip and slide the clip to disconnect the radiator hose outlet.
| 10. REMOVE PIPING CLAMP |
![]() |
Remove the piping clamp from the No. 1 cooler refrigerant discharge hose and No. 1 cooler refrigerant suction hose.
| 11. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor and pulley.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
| 12. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE |
![]() |
Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the compressor and pulley.
Remove the O-ring from the No. 1 cooler refrigerant suction hose.
| 13. REMOVE COMPRESSOR AND PULLEY |
Disconnect the connector.
![]() |
Remove the 4 bolts, engine wire harness bracket, and the compressor and pulley.