Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Engine Immobiliser System 
Symptom
Suspected Area
See page
Engine does not start.
Key
Click here
Steering lock ECU power source circuit
Click here
Entry and start system (for start function)
Click here
SFI system
Click here
Security indicator light is always on.
Certification ECU (smart key ECU assembly)
Click here
Wire harness or connector
-
Clock assembly
-
Security indicator light is off.
Certification ECU (smart key ECU assembly)
Click here
Wire harness or connector
-
Clock assembly
-