Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE HEADLIGHT CLEANER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E150394
  1. Extend the headlight cleaner nozzle.

  1. Disengage the claw and remove the headlight cleaner nozzle with nozzle holder as shown in the illustration.



    E183136
  1. Disengage the 2 claws and remove the headlight cleaner nozzle sub-assembly.



    E182203
  1. Disconnect the headlight washer hose.

  1. Remove the bolt.



    E182204
  1. Disengage the 2 claws and remove the headlight cleaner actuator sub-assembly.



2. REMOVE HEADLIGHT CLEANER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure for the RH side and LH side.



3. REMOVE HEADLIGHT CLEANER WASHER HOSE (w/ Headlight Cleaner System)


  1. Disengage the 5 clamps and remove the headlight cleaner washer hose.


    B137738



4. REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
  1. Disconnect the sensor connector.



    E134853
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 1 ultrasonic sensor.

    HINT:
    1. The type of the claw on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.
    2. The illustration is for the LH side. The RH side is the opposite of the LH side.



5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)


    E134854
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer from the front bumper.

    HINT:
    The illustration is for the LH side. The RH side is the opposite of the LH side.



6. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET


    B137742
  1. Remove the 2 screws.

  1. Disengage the 2 claws and remove the front bumper extension mounting bracket.



7. REMOVE FRONT BUMPER LOWER COVER


    B226380
  1. Disengage the 2 claws and remove the front bumper lower cover.



8. REMOVE FOG LIGHT ASSEMBLY LH


    E128199
  1. Remove the screw and the fog light assembly.



9. REMOVE FRONT BUMPER HOLE COVER LH


    B220948
  1. Disengage the 5 claws and remove the front bumper hole cover LH.



10. REMOVE FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.



11. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedure for the RH side and LH side.



12. REMOVE LOWER RADIATOR GRILLE


    B137731
  1. Disengage the 14 claws and remove the lower radiator grille.



13. REMOVE RADIATOR GRILLE


    B225459
  1. Remove the 2 screws.

  1. Disengage the 15 claws and remove the radiator grille.



14. REMOVE HOOD TO FRONT END PANEL SEAL


    B137233
  1. Remove the 10 clips and hood to front end panel seal.



15. REMOVE FRONT BUMPER UPPER RETAINER


    B137234
  1. Remove the 3 clips and front bumper upper retainer.



16. REMOVE RADIATOR GRILLE EMBLEM


    B137235
  1. Disengage the 4 claws to remove the radiator grille emblem.



17. REMOVE FRONT BUMPER ENERGY ABSORBER


    B220950
  1. Disengage the 2 guides and remove the front bumper energy absorber from the front bumper reinforcement sub-assembly.



18. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B220951
  1. Disengage the 6 clamps.

  1. Remove the 6 bolts and front bumper reinforcement sub-assembly.



19. REMOVE FRONT BUMPER SIDE RETAINER LH


    B137727
  1. Remove the screw.

  1. Disengage the claw to remove the front bumper side retainer LH.



20. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure for the RH side and LH side.