Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (w/ TOYOTA Parking Assist-sensor System)


2. REMOVE SPARE WHEEL COVER CLAMP (w/ TOYOTA Parking Assist-sensor System)


3. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ TOYOTA Parking Assist-sensor System)


4. REMOVE LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY (w/ TOYOTA Parking Assist-sensor System)


    B136853
  1. Remove the bolt.

  1. Disengage the clip and remove the luggage compartment side tray assembly.



5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/ TOYOTA Parking Assist-sensor System)


    B136879
  1. Remove the 2 screws and the 2 No. 1 luggage compartment trim hooks.



6. REMOVE REAR FLOOR FINISH PLATE (w/ TOYOTA Parking Assist-sensor System)


    B136852
  1. Disengage the 7 clips and remove the rear floor finish plate.



7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH (w/ TOYOTA Parking Assist-sensor System)


    B136854
  1. Remove the 2 clips and the luggage compartment inner trim cover LH.



8. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)


    B137209
  1. Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.



9. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/ Rear Fender Mudguard)


10. REMOVE REAR BUMPER ASSEMBLY (w/o TOYOTA Parking Assist-sensor System)


    B137211E01
  1. Put protective tape around the rear bumper assembly.



    B137212
  1. Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.



    B137214
  1. Remove the 6 screws and 2 clips.



    B137215
  1. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.



11. REMOVE REAR BUMPER ASSEMBLY (w/ TOYOTA Parking Assist-sensor System)


    B137211E01
  1. Put protective tape around the rear bumper assembly.



    B137212
  1. Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.



    B137214
  1. Remove the 6 screws and 2 clips.



    B189095
  1. Disconnect the connector.

  1. Disengage the grommet.



    B137215
  1. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.