Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)


    E163888
  1. Disconnect the connector.



    E163889
  1. Remove the sensor retainer as shown in the illustration.



    E163890
  1. Remove the No. 2 ultrasonic sensor as shown in the illustration.



2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)


    E163892
  1. Disconnect the connector.



    E163893
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor.



3. REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)


  1. Remove the 3 pieces of wiring harness tape and No. 2 luggage room wire.


    B189094E01



4. REMOVE REAR BUMPER PLATE LH


5. REMOVE REAR BUMPER PLATE RH


6. REMOVE REAR BUMPER PAD


    B146333
  1. Remove the rear bumper pad.

    HINT:
    Use the same procedure for the RH side and LH side.



7. REMOVE REAR BUMPER SIDE SUPPORT LH


    B137219
  1. Remove the 2 screws.

  1. Disengage the 3 claws to remove the rear bumper side support LH.



8. REMOVE REAR BUMPER SIDE SUPPORT RH


9. REMOVE REAR BUMPER SIDE RETAINER LH


    B137220
  1. Remove the 2 screws.

  1. Disengage the 3 claws to remove the rear bumper side retainer LH.



10. REMOVE REAR BUMPER SIDE RETAINER RH


11. REMOVE WHEEL HOUSE REINFORCEMENT LH


    B137221
  1. Remove the nut and wheel house reinforcement LH.



12. REMOVE WHEEL HOUSE REINFORCEMENT RH


13. REMOVE REAR BUMPER ENERGY ABSORBER


    B137210
  1. Remove the rear bumper energy absorber from the rear bumper reinforcement sub-assembly.



14. REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B137217
  1. Remove the 6 nuts and rear bumper reinforcement sub-assembly.