Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)
  1. Disconnect the 4 connectors.



  1. Disengage the 2 clamps and remove the No. 2 luggage room wire.


    B224152



2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
  1. for Back Sensor:
  2. for Corner Sensor:


3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
  1. for Back Sensor:
  2. for Corner Sensor:


4. REMOVE REAR BUMPER PLATE LH
  1. Disengage the 2 claws and remove the rear bumper plate LH.



5. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedure for the RH side and LH side.



6. REMOVE REAR BUMPER PAD


    B146333
  1. Remove the 2 rear bumper pads.



7. REMOVE REAR BUMPER SIDE SUPPORT LH


    B137219
  1. Remove the 2 screws.

  1. Disengage the 3 claws to remove the rear bumper side support LH.



8. REMOVE REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure for the RH side and LH side.



9. REMOVE REAR BUMPER SIDE RETAINER LH


    B137220
  1. Remove the 2 screws.

  1. Disengage the 3 claws to remove the rear bumper side retainer LH.



10. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure for the RH side and LH side.



11. REMOVE WHEEL HOUSE REINFORCEMENT LH


    B137221
  1. Remove the nut and wheel house reinforcement LH.



12. REMOVE WHEEL HOUSE REINFORCEMENT RH

HINT:
Use the same procedure for the RH side and LH side.



13. REMOVE REAR BUMPER ENERGY ABSORBER


    B137210
  1. Remove the rear bumper energy absorber from the rear bumper reinforcement sub-assembly.



14. REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B137217
  1. Remove the 6 nuts and rear bumper reinforcement sub-assembly.