Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > REASSEMBLY

for Preparation Click here



1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B137217
  1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }



2. INSTALL REAR BUMPER ENERGY ABSORBER


    B137210
  1. Install the rear bumper energy absorber to the rear bumper reinforcement sub-assembly.



3. INSTALL WHEEL HOUSE REINFORCEMENT LH


    B137221
  1. Install the wheel house reinforcement LH with the nut.



4. INSTALL WHEEL HOUSE REINFORCEMENT RH


5. INSTALL REAR BUMPER SIDE RETAINER LH


    B137220
  1. Engage the 3 claws and install the rear bumper side retainer LH.

  1. Install the 2 screws.



6. INSTALL REAR BUMPER SIDE RETAINER RH


7. INSTALL REAR BUMPER SIDE SUPPORT LH


    B137219
  1. Engage the 3 claws and install the rear bumper side support LH.

  1. Install the 2 screws.



8. INSTALL REAR BUMPER SIDE SUPPORT RH


9. INSTALL REAR BUMPER PAD


    B146333
  1. Apply new double-sided tape to the rear bumper pad.

  1. Remove the release paper from the rear bumper pad.

  1. Install the rear bumper pad.

    HINT:
    Use the same procedure for the RH side and LH side.



10. INSTALL REAR BUMPER PLATE LH


11. INSTALL REAR BUMPER PLATE RH


12. INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)


    E163893
  1. Engage the 2 claws and install the No. 1 ultrasonic sensor.



    E163892
  1. Connect the connector.



13. INSTALL NO. 2 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)


    E163891
  1. Install the No. 2 ultrasonic sensor as shown in the illustration.



    E163131
  1. Install the sensor retainer as shown in the illustration.



    E163888
  1. Connect the connector.



14. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)


  1. Using 3 pieces of new adhesive tape, secure the No. 2 luggage room wire as follows:

    1. Route the No. 2 engine room wire along the edge inside the rear bumper with the 3 pieces of marking tape positioned as shown in the illustration.

      NOTICE:
      Do not strain the No. 2 luggage room wire.



    2. Attach a piece of adhesive tape over each marking tape position to secure the No. 2 luggage room wire.


      B189093E01