Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > REASSEMBLY

for Preparation Click here



1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY


    B137217
  1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }



2. INSTALL REAR BUMPER ENERGY ABSORBER


    B137210
  1. Install the rear bumper energy absorber to the rear bumper reinforcement sub-assembly.



3. INSTALL WHEEL HOUSE REINFORCEMENT LH


    B137221
  1. Install the wheel house reinforcement LH with the nut.



4. INSTALL WHEEL HOUSE REINFORCEMENT RH

HINT:
Use the same procedure for the RH side and LH side.



5. INSTALL REAR BUMPER SIDE RETAINER LH


    B137220
  1. Engage the 3 claws and install the rear bumper side retainer LH.

  1. Install the 2 screws.



6. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure for the RH side and LH side.



7. INSTALL REAR BUMPER SIDE SUPPORT LH


    B137219
  1. Engage the 3 claws and install the rear bumper side support LH.

  1. Install the 2 screws.



8. INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure for the RH side and LH side.



9. INSTALL REAR BUMPER PAD


    B146333
  1. Apply new double-sided tape to the 2 rear bumper pads.

  1. Remove the release papers from the rear bumper pads.

  1. Install the rear bumper pads.



10. INSTALL REAR BUMPER PLATE LH
  1. Engage the 2 claws and install the rear bumper plate LH.



11. INSTALL REAR BUMPER PLATE RH

HINT:
Use the same procedure for the RH side and LH side.



12. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
  1. for Corner Sensor:
  2. for Back Sensor:


13. INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
  1. for Corner Sensor:
  2. for Back Sensor:


14. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)


  1. Engage the 2 clamps and install the No. 2 luggage room wire.


    B224153