Home › ENGINE · 2GR-FE › STARTING › STARTER CUT RELAY

STARTER CUT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STARTER CUT RELAY


    E034090E19
  1. Using an ohmmeter, measure the resistance between each terminal.

    Standard Resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (when battery voltage is applied between terminals 1 and 2)

    If the result is not as specified, replace the starter cut relay.