TIMING CHAIN > INSPECTION |
| 1. INSPECT CHAIN SUB-ASSEMBLY |
![]() |
Pull the chain with a force of 140 N (14.3 kgf, 31.5 lbf) as shown in the illustration.
Using vernier calipers, measure the length of 15 links.
| 2. INSPECT NO. 2 CHAIN SUB-ASSEMBLY |
![]() |
Pull the chain with a force of 140 N (14.3 kgf, 31.5 lbf) as shown in the illustration.
Using vernier calipers, measure the length of 15 links.
| 3. INSPECT OIL PUMP DRIVE SPROCKET |
![]() |
Wrap the chain around the sprocket.
Using vernier calipers, measure the sprocket diameter with the chain wrapped around.
| 4. INSPECT OIL PUMP DRIVE SHAFT SPROCKET |
![]() |
Wrap the chain around the sprocket.
Using vernier calipers, measure the sprocket diameter with the chain wrapped around.
| 5. INSPECT CHAIN TENSIONER SLIPPER |
![]() |
Using vernier calipers, measure the tensioner slipper wear.
| 6. INSPECT NO. 1 CHAIN VIBRATION DAMPER |
![]() |
Using vernier calipers, measure the vibration damper wear.
| 7. INSPECT CHAIN TENSIONER PLATE |
![]() |
Using vernier calipers, measure the vibration damper wear.
| 8. INSPECT NO. 1 CHAIN TENSIONER |
![]() |
Check that the plunger moves smoothly when the ratchet pawl is raised with your finger.
Release the ratchet pawl, then check that the plunger is locked in place by the ratchet pawl and does not move when pushed with your finger.