ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL |
| 1. REMOVE ENGINE UNDER COVER LH |
| 2. REMOVE ENGINE UNDER COVER RH |
| 3. DRAIN ENGINE COOLANT |
Remove the radiator cap sub-assembly from the radiator assembly.
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs, then drain the coolant.

| 4. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Hold the front of the V-bank cover and raise it to disengage the 2 retainers on the front of the cover. Continue to raise the cover to disengage the retainer on the rear of the cover and remove the cover.
| 5. REMOVE AIR CLEANER INLET ASSEMBLY |
![]() |
Remove the 2 bolts, clamp and air cleaner inlet.
| 6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the 3 vacuum hoses.
![]() |
Disconnect the mass air flow meter connector (*1).
Disconnect the No. 2 ventilation hose (*2).
Disconnect the hose band (*3).
![]() |
Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.
| 7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the vacuum hose and hose clamp.
Remove the 3 bolts and air cleaner case.
| 8. REMOVE NO. 1 AIR CLEANER INLET |
![]() |
Remove the bolt and No. 1 air cleaner inlet.
| 9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Remove the engine coolant temperature sensor connector.
Remove the engine coolant temperature sensor.