POWER DOOR LOCK CONTROL SYSTEM > Luggage Compartment Door Key Cylinder Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on and turn the intelligent tester main switch on.
Select the item below in the "DATA LIST" and read the display on the intelligent tester.
| Item | Measurement Item/Display (Range) | Normal Condition | Diagnostic Note |
| Trunk Lock/Unlock SW | Luggage compartment door key cylinder switch/ON or OFF | ON: Ignition key inserted and turned to lock position OFF: Ignition key inserted and turned to unlock position | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT MAIN BODY ECU (TSW TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| E6-2 (TSW) - Body ground | Luggage compartment door lock cylinder LOCK | 10 kΩ or higher |
| E6-2 (TSW) - Body ground | Luggage compartment door lock cylinder OPEN | Below 1 Ω |
| E6-2 (TSW) - Body ground | Luggage compartment door lock cylinder UNLOCK | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.INSPECT LUGGAGE COMPARTMENT DOOR LOCK CYLINDER |
![]() |
Disconnect the luggage compartment door lock cylinder connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| S6-2 - S6-1 | Luggage compartment door lock cylinder LOCK | 10 kΩ or higher |
| S6-2 - S6-1 | Luggage compartment door lock cylinder OPEN | Below 1 Ω |
| S6-2 - S6-1 | Luggage compartment door lock cylinder UNLOCK | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||