Home › TRANSMISSION ยท U660E AUTOMATIC TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT DIFFERENTIAL SIDE GEAR BACKLASH


    C083562
  1. Hold the differential case in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Place a dial indicator on the tip of the side gear tooth at a right angle.

  1. Hold the pinion gear in the differential case and measure the backlash of the side gear.

    Standard backlash:
    0 to 0.15 mm (0 to 0.0059 in.)

    Thrust washer thickness 
    Thickness
    Thickness
    1.50 mm (0.0591 in.)
    1.75 mm (0.0689 in.)
    1.55 mm (0.0610 in.)
    1.80 mm (0.0709 in.)
    1.60 mm (0.0630 in.)
    1.85 mm (0.07283 in.)
    1.65 mm (0.0650 in.)
    1.90 mm (0.07480 in.)
    1.70 mm (0.0669 in.)
    -
    If the backlash is greater than the standard range, select another side gear thrust washer.