Home › BRAKE › BRAKE CONTROL › ABS MOTOR RELAY (w/ VSC)

ABS MOTOR RELAY (w/ VSC) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VSC NO. 1 (FAIL SAFE) RELAY
  1. Remove the VSC No. 1 (fail safe) relay.



    F050241E13
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    Apply B+ between terminals 1 and 2
    Below 1 Ω

    If the value is not as specified, replace the VSC No. 1 (fail safe) relay.



2. INSPECT VSC NO. 2 RELAY
  1. Remove the VSC No. 2 relay.



    F050240E09
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    Apply B+ between terminals 1 and 2
    Below 1 Ω

    If the value is not as specified, replace the VSC No. 2 relay.