METER / GAUGE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester on.
Enter the following menus: Diagnosis / OBD/MOBD / Combination Meter / DTC Info / Current Codes.
Check for DTCs.
| CLEAR DTC |
Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester on.
Enter the following menus: Diagnosis / OBD/MOBD / Combination Meter / DTC Info / Current Codes.
Erase DTCs by pressing the YES button on the tester.