Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The combination meter assembly communicates with the ECM via the CAN communication lines (CAN No. 1 Bus).

DTC No.
DTC Detection Conditions
Trouble Areas
U0100
When either of following conditions detected:
  1. Vehicle speed 5 km/h (3.1 mph) or more and IG voltage 10.5 V or more
  2. No communication with ECM continues for 3 seconds or more (No communication to ECM or skid control ECU continues for 60 seconds or more)
  1. CAN communication system
  2. ECM

WIRING DIAGRAM


E124226E06


INSPECTION PROCEDURE

1.CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Diagnosis / OBD / MOBD / Combination Meter / DTC Info / Clear Codes.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs (Click herefor LHD, Click here for RHD).

    Result:
    Result
    Proceed to
    DTC output
    A (Click herefor LHD, Click here for RHD)
    DTC not output
    B



B
USE SIMULATION METHOD TO CHECK
A

GO TO CAN COMMUNICATION SYSTEM