MASS AIR FLOW METER > ON-VEHICLE INSPECTION |
| 1. INSPECT MASS AIR FLOW METER |
Perform confirmation driving pattern.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Clear the DTCs (Click here).
Start the engine and warm it up with all accessory switches OFF (until the engine coolant temperature is 75°C (167°F) or more).
Drive the vehicle at 50 km/h (31 mph) or more for 3 to 5 minutes (*1).
Allow the engine to idle for 2 minutes (*2).
Perform steps (*1) and (*2) at least 3 times.

Read values using the intelligent tester (LONG FT#1).
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / LONG FT#1.
Read the values displayed on the tester.
Read values using the intelligent tester (MAF).
Turn the ignition switch to the ACC position.
Turn the ignition switch to the ON position (do not run the engine).
Turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / MAF.
Wait 30 seconds, and read the values on the intelligent tester.