Home › BODY › WINDSHIELD / WINDOWGLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    B136445E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.



2. REMOVE DOOR ASSIST GRIP COVER


    B149028E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the door assist grip cover.



3. REMOVE REAR ASH RECEPTACLE ASSEMBLY


    B136442
  1. Remove the rear ash receptacle assembly.



4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B136449
  1. Remove the 3 screws.

  1. Using a clip remover, disengage the 7 clips.



    B136450
  1. Raise the rear door trim board to disengage the 4 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

  1. Disconnect the connector.



    B136453
  1. Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.



    B141704
  1. Disengage the clip as shown in the illustration and remove the No. 1 door scuff plate clamp from the rear door trim board.



5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP


    B136456
  1. Disengage the 3 clips as shown in the illustration and remove the rear door inner glass weatherstrip from the rear door trim board.



6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
  1. Disconnect the connector.



    B136458
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws and remove the rear power window regulator switch assembly.