Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH RH


    E130008E01
  1. Engage the 2 pins and install the steering pad switch LH.

  1. Install the screw.

  1. Connect the connector to the spiral cable.



2. INSTALL STEERING PAD
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.



    C133859
  1. Support the steering pad with one hand.

  1. Connect the 2 airbag connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector to the steering pad.

  1. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.



    C141759
  1. Using a "TORX" socket (T30), tighten the 2 "TORX" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



3. INSTALL NO. 3 LOWER STEERING WHEEL COVER


    C141760
  1. Engage the claw and install the No. 3 lower steering wheel cover.



4. INSTALL NO. 2 LOWER STEERING WHEEL COVER


    C142024
  1. Engage the claw and install the No. 2 lower steering wheel cover.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. INSPECT SRS WARNING LIGHT
(Click here)