STEERING PAD SWITCH > INSTALLATION |
| 1. INSTALL STEERING PAD SWITCH RH |
![]() |
Engage the 2 pins and install the steering pad switch LH.
Install the screw.
Connect the connector to the spiral cable.
| 2. INSTALL STEERING PAD |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
![]() |
Support the steering pad with one hand.
Connect the 2 airbag connectors to the steering pad.
Connect the horn connector to the steering pad.
Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
![]() |
Using a "TORX" socket (T30), tighten the 2 "TORX" screws.
| 3. INSTALL NO. 3 LOWER STEERING WHEEL COVER |
![]() |
Engage the claw and install the No. 3 lower steering wheel cover.
| 4. INSTALL NO. 2 LOWER STEERING WHEEL COVER |
![]() |
Engage the claw and install the No. 2 lower steering wheel cover.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. INSPECT SRS WARNING LIGHT |