Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here)



2. REMOVE NO. 3 LOWER STEERING WHEEL COVER


    C141756
  1. Using a screwdriver, disengage the claw and remove the No. 3 lower steering wheel cover.

    HINT:
    Tape up the screwdriver tip before use.



3. REMOVE NO. 2 LOWER STEERING WHEEL COVER


    C141757
  1. Using a screwdriver, disengage the claw and remove the No. 2 lower steering wheel cover.

    HINT:
    Tape up the screwdriver tip before use.



4. REMOVE STEERING PAD


    C141758E02
  1. Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.



    C133859
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector from the steering pad.

  1. Disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



5. REMOVE STEERING PAD SWITCH RH


    E130008E01
  1. Disconnect the pad switch connector from the spiral cable.

  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch RH.