VACUUM SWITCHING VALVE (for EVAP) > REMOVAL |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.
| 2. REMOVE NO. 1 VACUUM SWITCHING VALVE |
![]() |
Disconnect the 2 vacuum hoses and No. 1 vacuum switching valve connector.
![]() |
Remove the bolt and No. 1 vacuum switching valve.