Home › ENGINE ยท 2GR-FE › EMISSION CONTROL › VACUUM SWITCHING VALVE (for EVAP)

VACUUM SWITCHING VALVE (for EVAP) > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A132968
  1. Hold the front of the V-bank cover and raise it to disengage the 2 retainers on the front of the cover. Continue to raise the cover to disengage the retainer on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. REMOVE NO. 1 VACUUM SWITCHING VALVE


    A132952E01
  1. Disconnect the 2 vacuum hoses and No. 1 vacuum switching valve connector.



    A132953
  1. Remove the bolt and No. 1 vacuum switching valve.