FUEL SENDER GAUGE ASSEMBLY (for 2AZ-FE) > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
![]() |
Detach the 2 front hooks of the seat cushion from the vehicle body.
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat the step above for the other hook.
Remove the seat cushion.
| 4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
![]() |
Detach the 2 front hooks of the seat cushion from the vehicle body.
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat the step above for the other hook.
Remove the seat cushion.
| 5. REMOVE REAR FLOOR SERVICE HOLE COVER |
![]() |
Remove the rear floor service hole cover.
Disconnect the fuel pump connector.
| 6. SEPARATE FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Remove the tube joint clip, and pull out the fuel pump tube.
| 7. REMOVE FUEL TANK VENT TUBE SET PLATE |
![]() |
Remove the 8 bolts and set plate.
| 8. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
![]() |
Pull out the fuel suction tube from the fuel tank.
![]() |
Remove the gasket from the fuel suction tube.
| 9. REMOVE FUEL SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the fuel sender gauge connector.
![]() |
Unlock the fuel sender gauge, and slide it to remove.