Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND PULLEY (for 2AZ-FE)

COMPRESSOR AND PULLEY (for 2AZ-FE) > INSPECTION

for Preparation Click here



1. INSPECT COMPRESSOR AND PULLEY (A/C COMPRESSOR SOLENOID)


    E116970E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 1
    20°C (68°F)
    10 to 11 Ω

    If the resistance is not as specified, replace the compressor and pulley.