Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)


    E005280
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    (at 20°C (68°F))
    160 to 320 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.



2. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)


    E116970E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 1
    20°C (68°F)
    10 to 11 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.



3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH


    E005280E18
  1. Disconnect the connector from the compressor and magnetic clutch.



    E124482E03
  1. Disconnect the connector from the magnetic clutch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A-3 - B-1
    Always
    Below 1 Ω
    A-3 - Body ground
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the compressor and magnetic clutch.



4. INSPECT MAGNETIC CLUTCH


    E113611E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Always
    3.4 to 3.8 Ω

    If the resistance is not as specified, replace the magnetic clutch.

  1. When connector terminal 1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.

    OK:
    1):
    The magnetic clutch's operating sound can be heard.
    2):
    The magnetic clutch's hub and rotor lock.

    If the result is not as specified, replace the magnetic clutch.