EFI RELAY > INSPECTION |
| 1. INSPECT EFI RELAY |
![]() |
Using an ohmmeter, measure the resistance according to the value(s) in the table below.
| Tester connection | Specified Condition |
| 1E-9 - 1E-10 | Below 1 Ω |
| 1E-7 - 1E-12 | 10 kΩ or higher |
| 1E-7 - 1E-12 | Below 1 Ω (Battery voltage applied between terminals 1E-9 and 1E-10) |