DTC P0443 Evaporative Emission Control System Purge Control Valve Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0443 | Proper response to ECM command does not occur (1 trip detection logic) |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
![]() |
Disconnect the vacuum hose from the VSV for EVAP.
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for EVAP Control. Press the right or left button.
Check if air is sucked into the port when operating the VSV for EVAP using the intelligent tester.
| Tester Operation | Specified Condition |
| VSV is OFF | No air sucked |
Reconnect the vacuum hose.
|
| ||||
| NG | |
| 2.INSPECT PURGE VSV (OPERATION) |
![]() |
Disconnect the C6 purge VSV connector.
Measure the resistance between the terminals of the purge VSV.
Reconnect the purge VSV connector.
|
| ||||
| OK | |
| 3.INSPECT PURGE VSV (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the C6 purge VSV connector.
Turn the ignition switch to the ON position.
Measure the voltage between the terminal of the wire harness side connector and body ground.
| Tester Connection | Specified Condition |
| Purge VSV (C6-2) - Body ground | 9 to 14 V |
Reconnect the purge VSV connector.
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (ECM - PURGE VSV) |
![]() |
Disconnect the C6 purge VSV connector.
Disconnect the C58 (RHD) or C55 (LHD) ECM connector.
Measure the resistance between the terminals.
| Tester Connection | Specified Condition |
| Purge VSV (C6-2) - PRG (C58-108) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Purge VSV (C6-2) - PRG (C55-108) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Purge VSV (C6-2) or PRG (C58-108) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| Purge VSV (C6-2) or PRG (C55-108) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the purge VSV connector.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (EFI NO. 3 FUSE - ENGINE ROOM J/B (EFI RELAY)) |
![]() |
Inspect the EFI No. 3 fuse.
Remove the EFI No. 3 fuse from the engine room J/B.
Measure the EFI No. 3 fuse resistance.
Remove the engine room J/B from the engine room R/B.
Disconnect the C6 purge VSV connector.
Measure the resistance between the terminals.
| Tester Connection | Specified Condition |
| Purge VSV (C6-1) - Engine room R/B (1E-6) | Below 1 Ω |
Reinstall the engine room J/B.
Reconnect the purge VSV connector.
|
| ||||
| OK | ||
| ||