Home › TRANSMISSION · U660E AUTOMATIC TRANSAXLE › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ATF TEMPERATURE SENSOR ASSEMBLY


    C133224E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E2 - THO1
    90 Ω to 156 kΩ
    E2 - Body ground
    10 kΩ or higher
    THO1 - Body ground
    10 kΩ or higher

    HINT:
    If the resistance is out of the specified range with the ATF temperature assembly shown in the table below, the driveability of the vehicle may decrease.

    Standard resistance:
    ATF Temperature
    Specified Condition
    10°C (50°F)
    5.8 to 7.1 kΩ
    110°C (230°F)
    0.23 to 0.26 kΩ

    If the result is not specified, replace the ATF temperature sensor assembly.