Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends the microphone signal from the telephone microphone assembly to the radio receiver.
It also supplies power source from the radio receiver to the telephone microphone assembly.

WIRING DIAGRAM


E185464E02


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E163028E06
  1. Disconnect the radio receiver connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F29-3 (MACC) - Body ground
    Ignition switch to ON
    4 to 6 V

    Text in Illustration 
    *1
    Component without harness connected
    (Radio Receiver)



NG
REPLACE RADIO RECEIVER (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (TELEPHONE MICROPHONE ASSEMBLY - RADIO RECEIVER)


    E163029E07
  1. Disconnect the telephone microphone assembly and radio receiver connectors.



    E177704E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Q13-4 (SNS2) - F29-1 (SNS2)
    Always
    Below 1 Ω
    Q13-3 (Ml1+) - F29-2 (MIC+)
    Always
    Below 1 Ω
    Q13-5 (MlC-) - F29-5 (MIC-)
    Always
    Below 1 Ω
    Q13-1 (ACC) - F29-3 (MACC)
    Always
    Below 1 Ω
    F29-1 (SNS2) - Body ground
    Always
    10 kΩ or higher
    F29-2 (MIC+) - Body ground
    Always
    10 kΩ or higher
    F29-5 (MIC-) - Body ground
    Always
    10 kΩ or higher
    F29-3 (MACC) - Body ground
    Always
    10 kΩ or higher
    F29-6 (SGND) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Radio Receiver)
    *2
    Front view of wire harness connector
    (to Telephone Microphone Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)