AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver |

| 1.INSPECT RADIO RECEIVER |
![]() |
Disconnect the radio receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F29-3 (MACC) - Body ground | Ignition switch to ON | 4 to 6 V |
| *1 | Component without harness connected (Radio Receiver) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TELEPHONE MICROPHONE ASSEMBLY - RADIO RECEIVER) |
![]() |
Disconnect the telephone microphone assembly and radio receiver connectors.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q13-4 (SNS2) - F29-1 (SNS2) | Always | Below 1 Ω |
| Q13-3 (Ml1+) - F29-2 (MIC+) | Always | Below 1 Ω |
| Q13-5 (MlC-) - F29-5 (MIC-) | Always | Below 1 Ω |
| Q13-1 (ACC) - F29-3 (MACC) | Always | Below 1 Ω |
| F29-1 (SNS2) - Body ground | Always | 10 kΩ or higher |
| F29-2 (MIC+) - Body ground | Always | 10 kΩ or higher |
| F29-5 (MIC-) - Body ground | Always | 10 kΩ or higher |
| F29-3 (MACC) - Body ground | Always | 10 kΩ or higher |
| F29-6 (SGND) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Radio Receiver) |
| *2 | Front view of wire harness connector (to Telephone Microphone Assembly) |
|
| ||||
| OK | ||
| ||